If you are having mechanical problems in tuning session, the time you take to solve the problem will be billed at the same hourly rate.
Preparations to attend an appointment :
If you have problems mentioned above, you can make an appointment for repair while a week before the tuning session.
Preparations to attend an appointment :
- Remember to bring your wheel lock
- We use a dynamometer and a Motec wideband air/fuel gauge.
- We must remove the wheels of your car and insert the Air/Fuel probe in your exhaust.
- Please install a second oxygen sensor hole before the catalyst in the same manner as in the photo above.
- Make sure that you can not see the exhaust pipe through the ring to be welded to the nets. (18mm x 1.5mm)
- Make sure your engine is no lack of fluid (oil, cooling, etc.).
- Replace the liquid cooling system, DO NOT TUNE if your car tends to overheat.
- Ensure proper operation of the braking system and vehicle overall.
- Make sure you have secured your exhaust system and each junction are sealed.
- Make sure your exhaust manifold is SEALED.
- Make sure the air/fuel ration sensor hole is wide enough. (18mm X 1.5mm)
- Make sure the engine wire harness must not contain twisted bare wire and any wire connected with a good crimp or soldered in the right way.
- Make sure your alternator is working and the battery is in good condition.
- NEVER install a gas pump where the presence of dirt, rust or other contaminants in the tank.
If you have problems mentioned above, you can make an appointment for repair while a week before the tuning session.